I was recently in a situation where I had to do a fast upgrade of Citrix StoreFront from version 2.5 to 2.6 There are some new UI features that are not documented and not easy to change. The following will guide you through changing these new “features” of the UI.
I previously wrote an article (here) about building a NetScaler VPX Appliance in teh Amazon AWS Cloud. The next logical step it to put either a load balancer or a NetScaler Gateway on there to start to service your user base. This article will walk you through getting NetScaler Gateway running on your NetScaler VPN in AWS.
In this post I will walk you through building and configuring a Citrix NetScaler VPX appliance in the Amazon AWS Cloud. Once the device is up and running you can configure load balancing, NetScaler Gateway or a host of other services to be delivered from the Cloud to you On Premises or other cloud based applications.
This post is not going to run you through the install of Command Center but rather the configuration of the system once installed.
Some of you may have come across the issue where your End Point Analysis scans are not running when you apply the Symphony Theme or a custom theme to your NetScaler Gateway. Below if the process you will need to follow to fix this issue.
Was upgrading the NetScalers from 10.1 to 10.5 and came across a bug that will be useful to know about.
Most people will customize the NetScaler Gateway interface to suit there customers needs. Back in the good old days this could be done using the rc.netscaler file on boot but not you have to create a tar file and ns_gui_custom folders. Quite a bit more work but will persist during reboots.